Epoxy Countertops in Hayward, CA

Hayward has plenty of postwar homes with small kitchens, along with a fast-growing number of ADUs and rentals that need durable counters on a tight budget. We install epoxy countertops in Hayward, CA over existing tops, so you get a new surface without the cost and wait of fabricated stone.

(510) 880-3198

Get a Free Estimate

Tell us about the floor. Only your name and phone are required.

Form powered by splitforms

White marble-look epoxy countertop in a compact backyard ADU kitchen in Hayward, CA

Why epoxy works in Hayward

Hayward's neighborhoods were largely built in the 1950s and 1960s, from the flatland tracts near Mt. Eden and Tennyson to the hillside streets around Hayward Highlands and Cal State East Bay. A lot of those kitchens still have original tile counters with stained grout, or laminate that has peeled at the edges. Swapping them for quartz can be hard to justify, particularly in a small kitchen or a home you plan to rent.

Poured epoxy is a practical middle ground. It goes over sound laminate, tile, cultured marble and old solid surface. There is no demolition and no wait for fabrication, and the result is a seamless top with no grout lines to scrub.

ADUs, rentals and flips

The Bay Area's push to add housing has put a lot of granny units and garage conversions on Hayward lots. Those units need counters that look clean in listing photos and stand up to tenants. Epoxy is fast to install between move-outs and easy to repair: a scratch or a burn mark can be sanded and recoated rather than replaced.

Landlords with several units often choose one color for all of them, which keeps touch-ups simple. Investors flipping a house like how much a kitchen changes for the price of one pour.

Small shops and offices

We also coat counters for small businesses: checkout counters, salon stations, reception desks and break rooms in the industrial area west of the freeway. For food-prep areas, ask us about food-contact rated coatings and how the local health inspector views them before you choose a finish.

Installer pouring charcoal epoxy over old tile counters in a 1950s galley kitchen in Hayward, CA

Marine air and cure times

Hayward's weather is mild, but the air off the bay is damp. Morning fog and high humidity can slow epoxy curing and, if conditions are wrong, cause a cloudy film on the surface. We check humidity before every pour, close windows, and use a dehumidifier when needed. We also ask that the heat stay on during cooler months, since the coating needs a steady room temperature to harden properly.

Bay Area air quality rules limit solvent fumes, and we use low-VOC, solvent-free epoxy. You will notice a mild smell during the pour, but it fades as the coating cures.

Styles

  • Carrara-style white brightens a dark galley kitchen.
  • Calacatta gold veining gives a more luxurious look.
  • Matte concrete gray suits ADUs with a modern feel.
  • Black with silver or copper metallic works for bars and bold kitchens.

Edges, sinks and backsplashes

Older tile counters around Hayward often end in a bullnose tile edge and a short tile backsplash. We can coat both so the whole run reads as one surface, or keep the backsplash as it is and pour only the top if you plan to tile the wall later. Square laminate edges get a slightly rounded profile built up with filler before the pour, which helps the epoxy flow evenly and resists chipping.

Drop-in sinks are usually lifted out and set back on a fresh bead of sealant once the counter has cured. Undermount sinks stay put, and we coat right up to the rim. If the faucet is due for replacement anyway, this is a good time to do it, before the new top goes on.

Step by step

  1. We measure, check for water damage and loose material and confirm your design.
  2. We mask off cabinets, walls, floors and appliances.
  3. We sand and patch the old surface and build up edges as needed.
  4. We apply primer, the base color and the design layer.
  5. We finish with a clear top coat and let it cure, usually ready for light use in a day or two and full use in about a week.

Care

Use a cutting board, keep hot pots on trivets and clean with mild soap. Avoid harsh scouring powders. Treated this way, an epoxy top will look good for many years, and it can be refreshed with a new clear coat later on.

If your garage floor needs attention too, our garage floor epoxy and flake flooring crews can work in the same visit.

Get a countertop quote

Call (510) 880-3198. Tell us how many runs of counter you have, send a photo if you like, and we will set up a visit to measure and price it.