Driveway Coating in Hayward, CA

From the flat streets near Tennyson Road to the steep drives up in the Hayward hills, a lot of local concrete is long past its best. We coat driveways in Hayward, CA with UV-stable, textured systems that resist oil and stains and give you sure footing on a grade.

(510) 880-3198

Get a Free Estimate

Tell us about the floor. Only your name and phone are required.

Form powered by splitforms

Single-story 1950s tract home in Hayward, CA with a freshly coated gray flake driveway and a small front lawn

The problems we see on Hayward driveways

Hayward grew fast after World War II, and whole neighborhoods of small tract homes went up in the 1950s around Tennyson, Mt. Eden and Glen Eden. Their driveways are now 60 to 70 years old. Most are still structurally fine, but the surface has worn down to exposed sand, the joints are packed with weeds and years of oil from work trucks and project cars have soaked in. A coating is the cheapest way to make that slab look new again without breaking it out.

Up in the hills, the issue is different. Drives off Hayward Boulevard, Campus Drive and the streets around Cal State East Bay are often steep and curved. Morning fog and winter rain leave them damp and slick, and moss creeps in from the shaded edges. There the goal is grip and drainage as much as looks.

Why we use polyaspartic, not garage epoxy

Standard epoxy is excellent indoors but breaks down in sunlight. It yellows, chalks and gets brittle. Hayward driveways get strong sun most of the year, especially in the dry months from May to October, so we use polyaspartic and polyurea coatings that are UV stable. They stay flexible as the slab heats and cools, they resist hot-tire pickup when you pull in after a drive on the freeway, and they cure fast enough to have your car back in a day.

On top of the color coat we broadcast decorative flake if you want it, then seal with a clear topcoat mixed with fine grit. On flat drives we use a light texture. On steep hillside drives we use more, so shoes and tires hold even when the fog has left everything wet.

Steep hillside driveway in Hayward, CA with a tan textured anti-slip coating leading up to a split-level home

Cracks, the fault and the clay

The Hayward Fault runs right through town, creeping slowly enough that you can see offset curbs in a few older neighborhoods. Add the expansive clay soils in the hills and you get slabs that move a little every year. A coating cannot stop that. We fill stable hairline cracks before coating, and for cracks that are clearly still moving, we use a flexible filler and leave a visible joint rather than promise it will disappear. If a panel is badly sunk or broken, we will show you where it should be replaced before any coating goes on.

How a typical job runs

  • We pressure wash, degrease oil spots and scrape out joints.
  • Diamond grinding opens up the surface for a mechanical bond.
  • Cracks, spalls and chipped edges are patched and ground smooth.
  • Primer, color coat, optional flake and a textured clear topcoat go on.
  • You can walk on it the same evening and drive on it the next day in most weather.

Most single drives take one or two days. We plan around foggy mornings, because damp concrete needs to dry before coating. In winter we may start later in the day once the slab has warmed.

Parking, RVs and work trucks

Many Hayward homes park more cars than the garage can hold, and plenty of driveways carry a work van, a boat or a trailer. We use a thicker build where heavy tires sit and recommend plywood pads under trailer jacks and motorcycle kickstands, which can dent any coating on a hot afternoon.

Care and upkeep

Sweep or blow off leaves and dust, rinse every few months and wipe up oil drips when you notice them. Avoid harsh solvents. On shady hill drives, a yearly wash with a mild cleaner keeps moss from getting a start. The clear topcoat can be refreshed after several years to bring back the shine.

Choosing a color

Gray and charcoal blends hide tire marks and the dust that blows off the hills in late summer. Warmer tans suit the stucco and wood siding common on older homes. If your house sits close to the street, we can carry the color onto the front walk so the whole entry matches. We bring sample boards to the estimate so you can see them in your own light, and we can lay a small test section on the drive if you are torn between two.

Questions

Can you match my garage floor?

Yes. We can carry the same flake into the drive or pick a complementary color. See our garage floor epoxy page for that side.

What if I only want it sealed?

Our concrete sealing protects the slab without changing its look.

Do you serve nearby cities?

Yes, including Union City, San Lorenzo, Castro Valley and Fremont.

Price your driveway coating

Call (510) 880-3198. We will measure the drive, check the slope and moisture and send a written estimate.